Distantier marire ecartament H&R TRAK+® Wheel Spacers argintiu 1024566 pentru Opel Corsa A Hatchback 1.4 S (F08, M08, F68, M68) - 72 cai benzina

Pentru masina:

Opel Corsa A Hatchback 1.4 S (F08, M08, F68, M68)

Motor:

72 cai - 53 kW - benzina

Cod producator:

1024566

Producator:

limită inferioară adâncime de presare punte față [mm]:

23 mm

limită inferioară adâncime de presare punte spate [mm]:

23 mm

Dimensiune filet:

M12x1,5

Largire ecartament pe axa [mm]:

10 mm

Grosime [mm]:

5 mm

Numar gauri:

4

Asezare gauri Ø [mm]:

100 mm

Diametru de centrare [mm]:

56,6 mm

Culoare:

argintiu

Tip inmatriculare:

cu expertiză TÜV®

urmariti indicatiile de montaj:

Informatii generale:

Please note additional information and vehicle-specific technical notes!

Informatii generale:

DR = The wheel spacer should be fitted between the wheel and the axial hub using longer bolts not supplied - please order separately. When ordering the longer bolts please state which cone type you require (i.e. taper, round, loose round or flat) and the required extra length. All screws for the DR systems have to be orderded separately.

Informatii generale:

For all cars with 4-hole wheel.

Informatii generale:

All DR-Systems require longer wheel-bolts. These have to be ordered separately. When ordering wheel-bolts please follow these guidelines: If possible name the type of the wheel when ordering. New bolts must be longer than the original ones by half of the total Track-widening. For example: With a 30 mm DR-kit you will require bolts that are 15 mm longer than the original bolts. The bold-head must be identical to the existing bolt: Taper 60° Round-head for M12/d24 mm, for M14/d28 mm Round-head for M12/d26 mm (e.g. OE VAG-wheels) Flat-head with disc for CITROEN/PEUGEOT-vehicles M12x1,25 Flat-head for PORSCHE-original-wheels M14x1,5 Safety Guidelines (No. of turns for wheel screws) M12x1,5 = 6,5 turns = approx. 10 mm of load bearing shaft length M12x1,25 = 8,0 turns = approx. 10 mm of load bearing shaft length M12x1,75 = 6,5 turns = approx. 12 mm of load bearing shaft length M14x1,5 = 7,5 turns = approx. 12 mm of load bearing shaft length 1/2"UNF = 8,0 turns = approx. 11 mm of load bearing shaft length Please ensure that the wheel screws do not damage any part of the brake system (ABS sensors etc.) Turn the wheel first by hand and check clearance on the inside (max. tolerance for some vehicles is only 2 mm (RA Mercedes).

Informatii generale:

These spacers without a double-sided centering are only useable for cars with a sufficient length of the centering to be able to center the wheels enough despite the spacer.